最新の6103問題集で試験を準備する

Avaya 6103 試験概要:

Avaya 6103 試験シラバストピック:

Avaya ERS 8000 and Avaya VSP 9000 Implementation 認定 6103 試験問題：

1. Which CLI command is used to validate that synchronization for High Availability mode is correct?

A) show ha-all
B) show ha-state
C) show ha-sync
D) show ha-info

2. The attempt to manage an Ethernet Routing Switch (ERS) 8000 using a VRRP address was unsuccessful.
What is causing this problem?

A) The datacenter interface is set as a critical IP interface.
B) A real IP address is required for management access not a VRRP address.
C) The incorrect MAC offset is configured for the VRRP address.
D) The virtual router identifier is 0.

3. After experiencing issues with XFPs, the show sys pluggable-optical-modules info CLI command is used to find the switch that does not recognize the XFPs.
What is another method that can be used to view the XFP compatibility?

A) Ensure that the config sys is set for pluggable-optical-module info.
B) Check for port alarms.
C) Show the DWDM-XFP {detail}.
D) Select Edit, Port, General, DDI/SFP from the Enterprise Device Manager.

4. In a VSP 9000 chassis, which command is used to see the information on the installed software?

A) show sys software
B) show software
C) show sys installed
D) show sys boot

5. How do the Switch Fabric (SF) modules provide bandwidth management across the I/O modules?

A) The SF module in slot SF1 provides bandwidth management for the I/O modules in slots 1-5, while the SF module in slot SF4 provides bandwidth management for slots 6-10.
B) The bandwidth management is handled by the CP modules.
C) The SF module in slot SF1 provides bandwidth management for even numbered slots (2,4,6,8,10), while the SF module in slot SF4 provides bandwidth management for odd numbered I/O slots (1,3,5,7,9).
D) Bandwidth management is shared across all installed SF modules.
E) SF modules in slots SF1 and SF4 provide bandwidth management across the I/O modules.

質問と回答：