最新の1Y0-740問題集で試験を準備する

Citrix 1Y0-740 試験概要:

Citrix 1Y0-740 試験シラバストピック:

Citrix WANScaler 4.2: Administration 認定 1Y0-740 試験問題：

問題 #1

Scenario: A system administrator deployed a WANScaler 8500 appliance at one branch office and a WANScaler 8800 appliance at the headquarters office. Given the nature of the data transfers that are routinely used between the two offices (including database replication, multiple file transfers and directory synchronization), the administrator decides to use disk-based compression.
After several days of testing, the administrator could not explain why the compression ratio was below the expected level.
What are four possible reasons why the compression ratio was below the expected level?
(Choose four.)

A. File types with little to no redundancy will not compress well.
B. The WANScaler 8500 appliance does not support disk-based compression.
C. The WANScaler is not suited for compressing CIFS traffic.
D. WANScaler appliances must be deployed as matched pairs.
E. Compressibility of data is affected by the application protocol used.
F. Compression ratios are data-dependent.
G. Encryption of the data has a negative effect on compressibility.

問題 #2

Which two non-proprietary, licensed compression algorithms does the WANScaler appliance use? (Choose two.)

A. GZIP
B. LZS
C. JPEG
D. ZLIB

問題 #3

Scenario: A humanitarian organization is delivering food supplies to a disaster area, and the logistic team needs access to a database at their headquarters in order to determine the food supply inventory. The network traffic from the disaster area to the headquarters is TCP-based. The Network Administrator has been instructed to ensure, if the requirement exists, that the TCP accelerated traffic in this environment has access to 90% of the 1.5 Mbps WAN link.
Which bandwidth management rate will ensure that 90% of the bandwidth is assigned to accelerated traffic regardless of packet loss?

A. Hardboost
B. Softboost
C. Partial bandwidth
D. Full bandwidth

問題 #4

An administrator is configuring bandwidth settings for WANScaler in an environment that has unaccelerated latency sensitive traffic. What should the administrator configure to ensure that the unaccelerated traffic is not suppressed by the accelerated traffic?

A. The bandwidth limit for the unaccelerated traffic on the WANScaler appliance to 90% of the maximum link speed
B. A service class policy for the unaccelerated traffic and give that policy the highest priority
C. The WANScaler appliance to use softboost
D. The WANScaler appliance to use partial bandwidth

問題 #5

An administrator is implementing a WANScaler appliance in WCCP mode in a single LAN, single WAN implementation. What is the minimum number of Ethernet cables required to set up the WANScaler appliance on the local LAN?

A. 2
B. 1
C. 3
D. 4

解説：